Before the centrifuge is operated, the power should be cut off and the centrifuge brake should be loosened first. You can manually turn the drum to see if there is any bite.
Check for other parts of the area for looseness and abnormality.
Turn on the power and start in a clockwise direction (usually about 40-60 seconds from standstill to normal operation).
Usually, each equipment must be operate for about 3 hours after it arrives at the factory. It can work without abnormal conditions.
Place the material as evenly as possible.
Must be operated by a person, the capacity must not exceed the rated amount.
Never overspeed the machine to avoid affecting the life of the machine.
After the machine is started, if there is any abnormal situation, it must be stopped for inspection, and if necessary, it should be disassembled and repaired. .
The centrifuge is running at high speed, so it is not possible to touch the drum with the body to prevent accidents.
The number of filter cloths should be determined according to the size of the solid phase particles of the separated material, otherwise the separation effect will be affected. In addition, when installing the filter cloth, insert the filter cloth sealing ring into the drum sealing groove to prevent the material from running in.
In order to ensure the normal operation of the centrifuge, the rotating parts should be refueled and maintained every 6 months. At the same time, check the lubrication condition of the bearing, whether there is wear phenomenon; whether there is wear condition of the components in the brake device, and replace it severely; whether there is oil leakage in the bearing cover.
After the machine is used, it should be cleaned and kept clean.
Do not separate the non-preservative centrifuge from the highly corrosive materials; in addition, strictly follow the equipment requirements and regulations, non-explosion-proof centrifuges should not be used in flammable and explosive places.